Fiamma® 98655-728 Aluminum Wall Brackets for Awning Legs

Awesome service, personal and accurate

These brackets were easy to install on our sprinter van. In the rear we attached the wall bracket screws to a small block of plywood. We had access above the wheel well since we had an open panel van. In the front we temporarily used the supplied screws directly in the body panel between the front and sliding door. Ultimately we will drill bigger holes and put anchor nuts with a kind of rivet gun. At first it was difficult to put the arms in the wall brackets because the tilting leg at the end of the arm wouldn't tilt enough. We found that we could correct this problem by just filing a little bit off the end of the arm so that the two hole foot could pivot easily. Then the bracket works really well at any angle..

Perfect original replacement parts. Shopped all over the internet for them and finally found them at Panther products. Great website and so easy to use. Thanks to Panther Products.

great customer service, will continue to be a customer

Installation was fairly simple after the original brackets were removed. “Foot” of awning pole does not quite fit completely into the bracket, however. I plan to use a Drexel tool and carbide wheel to trim down the foot so that it will fit.

The wall brackets that came with the awning were made of cheap plastic and I knew it was only a matter of time before they broke. These are solid and high quality, I'm not worried about them breaking anytime soon and they look great

Product was shipped timely and as described in the website.

I knew when I had new awning installed and saw those plastic brackets they weren’t going to last long. Hopefully these do!

Exact replacement